对于任何类型的航空器而言,任何转动的触发都需要由对于质心的力矩引起。对于滚转力矩这里标注为Cl 从图三可以看出究竟是左滚还是右滚,还是不滚都是有伞绳的长度和翼伞的弯度来决定。(译者:大家注意一下啊,这里的质心是指整个系统的质心,不是指人的质心,不过由于伞头和伞绳的质量比较小,系统质心基本在人这一端)
For any kind of aircraft, the rotation movements occur at the centre of gravity (CG) and can be characterized with the moment of rotation at this point (the moment coefficient for the roll is called Cl). Everything is based on the shape of the arch and the length of the lines. Figure 3 explains why acting on the brake initiate a turn, or inverse roll on a canopy with an arch too “flat”(figure 3).

figure 3 : roll moment as a function of arch and lining height
Therefore, the roll momentl can either be positive, negative or null depending on the following fundamental design drivers:
因此滚转力矩Cl为正还是为负,或者为零由以下设计特点决定
1. . The shape of the arc
2. . The length of the lines that fixes the position of the centre of gravity
3. . The spread of the braking along the trailing edge
1 伞的弯曲形状
2 伞绳的长度,决定了质心位置
3 刹车在后缘的分部情况
The yaw moment is created by the increase of the drag of the left flap and the increase
of the induced drag of the left wing.
刹车产生的阻力在航向上的作用通常是有利于转弯的,但是在一些高性能伞上阻力产生很小。
It is always in the “good” direction because it is always on the side of the swung flap.
If the airfoil of the wing is too high performance and does not drag enough some
manufacturers use drag devices on the wingtip (Advance on the Sigma and Omega).
Why is a canopy spiral stable or in stable?
为何有的伞头是螺旋稳定的,有的不是?
In a stabilised turn, the paraglider is the aircraft with the record of the smallest turning circle, as shown in figure 4 comparing paraglider, hang-glider and sailplane.

figure 4 : turn radius comparison
图四:转弯半径的比较
在一个稳定的盘旋中,滑翔伞保持了航空器的最小盘旋半径的记录,图四是滑翔伞同悬挂滑翔机和固定翼滑翔机的比较
To give you a simple idea, one can say for instance that a paraglider usually turns with a radius of 2 wingspans, where a hang-glider and sailplane turn respectively with a radius of 3 and 4 wingspan The speed ratio between the left and right wingtip is from the above example; 2 for a paraglider but only 1.5 for a hang-glider and 1.3 for a sailplane. Therefore, the lift ratios, proportional to that square of speed as we know, are respectively 4 for a paraglider, 2.25 for a hang-glider and only 1.7 for a sailplane. Hence, even with symmetrical control, the lift spread along the wingspan varies greatly on a turning paraglider, as shown on figure 5.
为了比较简单的说明,这里以实例进行说明:滑翔伞以2倍翼展的半径稳定盘旋,而悬挂滑翔机和固定翼滑翔机以3,4倍翼展进行稳定盘旋。在如上的例子中,左右翼尖的的速度差别对于滑翔伞是2,对悬挂滑翔机是1.5,对于固定翼是1.3。由于升力于速度的平方成正比,因此在对称操作的情况下,小半径稳定盘旋的滑翔伞展向升力分布变化是非常大的,参见图五:

figure 5 : lift variation along span, in turn
图五:小半径盘旋的滑翔伞升力的展向变化
滑翔伞的螺旋稳定性由如下设计参数决定
Modifying the symmetry, according to the same “design drivers”, of the lift spread can cause either a stability or instability in spiral:
1. Shape of the arc (more or less flat)
2. Length of the lines
3. Spread of the braking along the trailing edge
1 伞的弯曲形状
2 伞绳的长度
3 刹车在后缘的分部
图六显示了三种可能
Figure 6 shows the different cases that can occur:
1. First case: with a flat arch and/or short lines, a paraglider is subjected to an inside induced roll and tends to engage in the turn (spiral instability)
第一种情况弧度很平的伞或者伞绳比较短的伞,其升力分部是趋向于减小盘旋半径,螺旋不稳定 2. Second case: with curved arch and/or long lines, a paraglider is subjected to an inverse induced roll and tends to exit the turn (spiral stability)
弯度比较大的伞或者伞绳比较长的伞,升力分部趋向于向外转动,增加半径,螺旋稳定
3. Third case: if arch and line length are combined to obtain a null moment, the paraglider stays at constant bank angle(neutral in spiral).
第三中情况,中性稳定,转动力矩为零

figure 6 : spiral stability
Obviously the results obtained for a canopy for a given bank angle have no reason to be the same for a different angle, this explains the strange or even dangerous behaviour of some models.
显然同一顶伞在不同半径盘旋的时候,所产生的表现是不相同的,这就解释了某些设计在某些状况下是非常危险的。
As a rule of thumb, the certified canopies on the market (not all of them…) are usually rather spiral stable or spiral neutral for “normal” bank angle. This explain, still as a rule of thumb, that constant bank angle needs for this canopy continues application of the inside brake to compensate the speeds spread and cancel the inverse induced moment roll, as shown in figure 7.
所以,上市的伞(当然也并非所有上市的伞)通常在常见的倾角下都是螺旋稳定的,至少是中立稳定的,这也就解释了为何要保证稳定的螺旋(而不改出),需要保持内侧的刹车,以平衡由内外速度差异导致的改出力矩,如图七:

figure 7 : stabilized turn
Are this thoughts of any use?
这些道理有啥用呢?
They are probably essential for a paraglider designer since they allowed for a new project with the right computational tool to determine the curve of the canopy, the length of the lines and the spread of the braking. Admittedly, you still have to do many long and meticulous tests and tunings to refine the turning behaviour. This is where with a lot of means, pilots and prototypes professional manufacturers make the difference with small amateurs. However, nowadays, a designer can almost guaranty that a paraglider will fly “properly” straight out of the computer.
对于设计者而言,明白这些理论结合现代计算工具可以方便的确定伞的形状和伞绳的长度,可以减少为了取得优异的转弯性能而做的很多费时费钱费料的原型号伞飞行试验和调试工作,而这些飞行试验和调整工作正是职业的厂家和飞行员比业余设计者所不同的地方。所以,现代设计师几乎能够完全保证一个能够正常表现的滑翔伞从计算机中“飞”出来!
For the average pilot, they will help him/her to know better his/her or other canopies, to understand them and appreciate piloting them avec the feeling the one knows a bit more of these wonderful flying machine.
对于普通的爱好者而言,可以更加深入的了解他们的滑翔伞从而更好的飞行。
Finally, I would very satisfy if my modest contribution could prevent what you can hear a the “terrasse du Planfait” or somewhere, even read in some “specialized” media: the never-ending speech on the completely mysterious and extraordinary complex nature of paraglider turns, so complicated that even the major aero-spatial companies would not have cracked it! |